I am doing an exact replacement (old device failed) on HS3 PRO with Z-NET PLUS of a Leviton Vizia 4-button zone controller RZCZ4-1LX. I have successfully REMOVE whatever factory network was on the new device and also did a factory reset. When I go into my Z-NET Plus management page and START an ADD NODE operation and then press and buttons 1 and 3 on the device, it says ADDING NEW NODE but then fails. What am I doing wrong. The Levitin instructions say use there hand held which I don't have to add to network.
Announcement
Collapse
No announcement yet.
Leviton Vizia 4-button zone controller RZCZ4-1LX can not ADD to HS3
Collapse
X
-
Here is error message.
Add Node started...
Activate the 'Add to Network' function on the device...
Activate the 'Add to Network' function on the device...
A new node is being added...
Error - Add Node Failed reported by controller - you may try again. A "Restart" has been done on your controller.ID: 6DF0950AC174 + Controller Node Information:
-
did you ever figure this one out? i have a cooper RFWDC that is doing the same thing
HS3 Pro on Windows 8 64bit
53 Z-wave nodes(46 devices, 7 remotes), 15 DS10a's, 10 ms16a's, 9 Oregon Sensors, W800, RFXCOMtrx433, Way2Call, 3 HSTouch Clients, 2xRussound CAS44, Global Cache GC100-12,10 Rollertrol blinds(+ zwave) ,3 Squeezebox Radios and 1 Squeezebox Boom,DMX Arduino via ethernet,Rain8Net,3x Echo Dot's
Check out my electronics blog here:
https://www.facebook.com/RaptorsIrrationalInventions
Comment
Comment