Status graphics

[wilkeslr]

Is there any way to remove the status graphic assigned to virtual devices?

I have created devices and tried to remove the status graphic assigned to them by deleting it in the device property page, but the default status graphic stays as in the image below

[mrhappy]

Unfortunately not (easily anyway) - this is a long standing issue for virtual devices (I take it you have created these devices yourself?) that unless you take over the interface parameter you will get these - see here http://forums.homeseer.com/showthread.php?t=166047

[rmasonjr]

Try changing the Device Type to a Status Only device (first tab).

[wilkeslr]

Thanks both. The devices were manually created and are already set as status only. I'll give the suggestions in the linked post a try.

[randy]

My solution is to use a 1 pixel by 1 pixel transparent spacer as an image. I attached the spacer.gif and gave an explanation in this post. You can assign it to individual values or to a range. It is simple and it works.