HS3 Pi Installation

[racerfern]

AFA the sudousers file, I still get homeseer is not the sudoers file. This incident will be reported.

It also fails when in SSH session.

[Pete]

To make homeseer a sudo user just type:

sudo usermod -aG sudo homeseer

Typically here create a homeseer and personal username user and make them both sudo users.

[zwolfpack]

zwolfpack The result of ifconfig is:

ifconfig
eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether b8:27:eb:bf:09:69 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1000 (Local Loopback)
RX packets 41731 bytes 6556042 (6.2 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 41731 bytes 6556042 (6.2 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.1.53 netmask 255.255.255.0 broadcast 192.168.1.255
inet6 fe80::b165:3d2b:a8a3:6a22 prefixlen 64 scopeid 0x20<link>
ether b8:27:eb:ea:5c:3c txqueuelen 1000 (Ethernet)
RX packets 283938 bytes 78566615 (74.9 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 43442 bytes 7153480 (6.8 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

This indicates that the wired interface (eth0) is down (no IP address), and wireless (wlan0) is up with address 192.168.1.53. Does this sound right?

[zwolfpack]

AFA the sudousers file, I still get homeseer is not the sudoers file. This incident will be reported.

It also fails when in SSH session.

Couple things

1) which user did you use to run the installer? That obviously has sudo capability.

2) Verify that the file at /etc/sudoers.d/010_homeseer-nopasswd was correctly written with contents

homeseer ALL=(ALL) NOPASSWD: ALL

I just re-verified it works properly here.

3) verify that the sudoers file /etc/sudoers hasn't been altered from the distribution and contains this line:

#includedir /etc/sudoers.d

The solution in post #17 works ok too, after the homeseer user logs out & back in; however it requires the password to be entered each time.

[racerfern]

This indicates that the wired interface (eth0) is down (no IP address), and wireless (wlan0) is up with address 192.168.1.53. Does this sound right?

That is correct. I disconnected the wired lan because I know my son is probably use it wirelessly.

[racerfern]

I have the wifi VNC working, it wanted the original username and password. No ETH0 required, working fine. thanks.