After I upgraded my HS3 to a new HomeTroller+ with HS4, my very old Kwikset Dead Bolts did not work properly.
I bought and tried to install a Z-Wave Plus Kwikset 916 Dead Bolt
It will not add properly, or do anything
I tried multiple times to
1. Remove the device, before then Add/Include
2. I tried Factory Resetting the Lock, then Remove followed by Add/Include again
3. Multiple Rescans of the created Device.
All I ever see in My Log is
(Last log entry on top)
Enabling Lock status for Kwikset device node 159 Z
Node 159 is a Z-Wave Plus node. Retrieving ZWPlus Info...
Node: 159 Supports Class(es): ZWAVEPLUS_INFO, MANUFACTURER_SPECIFIC_V2, DEVICE_RESET_LOCALLY, SECURITY, POWERLEVEL, FIRMWARE_UPDATE_MD
Z-Wave manufacturer information for node 159, ID: 144=90H (Kwikset), Type: 3=3H, ID: 1602=642H
If this is an import, you may need to remove and add the device as some devices cannot be added with an import.
Failed to get a SECURITY SCHEME or verify the key from node 159. Device may not be added properly to HomeSeer.
Adding using S0 Security, Negotiating or Verifying SECURITY SCHEME for node 159
Synchronize nodes finished. Number of device nodes to be created/added = 1
Z-NET Office: Controller firmware version: 4.31
Z-NET Office: Controller Manufacturer: Express Controls, ID=0x2, Type=0x5
Done. Node 159 Added.
One Device with no controls or features is all that is created with the name Kwikset Entry Control.
Any suggestions are greatly appreciated.
I bought and tried to install a Z-Wave Plus Kwikset 916 Dead Bolt
It will not add properly, or do anything
I tried multiple times to
1. Remove the device, before then Add/Include
2. I tried Factory Resetting the Lock, then Remove followed by Add/Include again
3. Multiple Rescans of the created Device.
All I ever see in My Log is
(Last log entry on top)
Enabling Lock status for Kwikset device node 159 Z
Node 159 is a Z-Wave Plus node. Retrieving ZWPlus Info...
Node: 159 Supports Class(es): ZWAVEPLUS_INFO, MANUFACTURER_SPECIFIC_V2, DEVICE_RESET_LOCALLY, SECURITY, POWERLEVEL, FIRMWARE_UPDATE_MD
Z-Wave manufacturer information for node 159, ID: 144=90H (Kwikset), Type: 3=3H, ID: 1602=642H
If this is an import, you may need to remove and add the device as some devices cannot be added with an import.
Failed to get a SECURITY SCHEME or verify the key from node 159. Device may not be added properly to HomeSeer.
Adding using S0 Security, Negotiating or Verifying SECURITY SCHEME for node 159
Synchronize nodes finished. Number of device nodes to be created/added = 1
Z-NET Office: Controller firmware version: 4.31
Z-NET Office: Controller Manufacturer: Express Controls, ID=0x2, Type=0x5
Done. Node 159 Added.
One Device with no controls or features is all that is created with the name Kwikset Entry Control.
Any suggestions are greatly appreciated.
Comment