Announcement

Collapse
No announcement yet.

Wake up devices

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Wake up devices

    I bought some Dome motion sensors which HS isn't picking up in a part of my house. When I try to check the Z-Wave connection or optimize HS says "the device must be woken up manually to use the functions below". I'm not really sure how to do that. I'm trying to figure out if moving my Z-Tool+ will work or if I should buy another one. My house is only 2500 sq ft.

  • #2
    The manual for the Dome sensor should indicate how to wake it up. Quite often it is the same steps as putting it in inclusion mode.
    HS 3.0.0.548: 1990 Devices 1172 Events
    Z-Wave 3.0.1.262: 126 Nodes on one Z-Net

    Comment

    Working...
    X