I have just upgraded to HS4 from HS3 and with a few exceptions, everything went well. My Arduino plugin for HS3 even worked perfectly, but I noticed it showed as unregistered, even though it was registered in HS3. I decided to upgrade to the HS4 plugin, which was a BIG mistake! Now my Arduino is no longer recognized and I was forced to set it up all over again. Unfortunately, that didn't work as several others have testified, with an "error adding new board = Do not set Image directly". I noticed that a new Beta 4.0.2.17 seems to have resolved the problem for some others and I would like to try it too, but I can't figure out how to load that Beta. I can't find it anywhere and suppose it has to be installed directly from the purchase page, which is only showing version 4.0.2.7, the same as the version I registered and am running.
Announcement
Collapse
No announcement yet.
How do I find Beta for Arduino Plugin HS4
Collapse
X
-
At the top right of the page where you install plugins there is a slider you need to press to show Beta plugins. It should then be listed.
Greig.Zwave = Z-Stick, 3xHSM100� 7xACT ZDM230, 1xEverspring SM103, 2xACT HomePro ZRP210.
X10 = CM12U, 2xAM12, 1xAW10, 1 x TM13U, 1xMS13, 2xHR10, 2xSS13
Other Hardware = ADI Ocelot + secu16, Global Cache GC100, RFXtrx433, 3 x Foscams.
Plugings = RFXcom, ActiveBackup, Applied Digital Ocelot, BLDeviceMatrix, BLGarbage, BLLAN, Current Cost, Global Cache GC100,HSTouch Android, HSTouch Server, HSTouch Server Unlimited, NetCAM, PowerTrigger, SageWebcamXP, SqueezeBox, X10 CM11A/CM12U.
Scripts = Various
Comment