Jasco (GE Enbrighten) Ceiling Fan Controller-High/Medium/Low

[JimFoster]

I purchased a Jasco/GE Ceiling Fan controller. When I installed it and added it to HomeSeer, it just sees it as an on/off switch.

Is there something further that I need to do so that HomeSeer can see the High/Medium/Low functionality of this switch?

[mulu]

Which model do you have? What happens when you exclude it and then include it again? What are the messages in HS during the inclusion process?

[George]

It should see it as a dimmer.

What you have to do is remove the slider section and create 3 new value pairs.

33 - 33% = LOW
66 - 66% = Medium
99 - 99% = High

There are only 4 values it recognizes 0-Off and the above.