HomeSeer SmartStick+ (G3) - unable to restore

[russr999]

Hi rjh - using the new Zwave plugin (v4.0.0.0) - I was not able to restore to it.

• Zwave interface is: Z-Wave Plus USB SmartStick + (G3)
• backup was taken about 15 minutes before trying a restore

I'm assuming this is just teething bugs in the new plugin?

[rjh]

We restore all the time here, it should work. Shot down HS4, then power cycle the SmartStick by unplugging it. Then start up HS4 again. See if you can restore. The error you see seems to indicate that the stick is not a G3 stick. If it is, then the power cycle might help. It is not reading the correct firmware version from the stick.

Hi rjh - using the new Zwave plugin (v4.0.0.0) - I was not able to restore to it.

• Zwave interface is: Z-Wave Plus USB SmartStick + (G3)
• backup was taken about 15 minutes before trying a restore

I'm assuming this is just teething bugs in the new plugin?