So I had added all of my Zigbee Iris 3210-L plugs to HS4 last week just to make sure that they all worked, which they did. So I went in under Managed Devices today and deleted them all because I'm not currently using them. After they were all deleted I go to devices, which still has the Zigbee filter set and I noticed two of my plugs are back, then the screen refreshes and 3 are back. Over the coarse of 30 - 45 seconds all of the plugs magically come back.
Now mind you none of then are even plugged in they are setting in the drawer. So I tried plugging one of them in and the PI can't control it or even show the current status at least not right away. After about 5 minutes the screen updates and shows the one plug setting in the wall is on and it will now respond to Off, On and toggle.
I should say I'm running Zigbee PI 4.0.6.0 on HS4 version 4.0.5.0
Now mind you none of then are even plugged in they are setting in the drawer. So I tried plugging one of them in and the PI can't control it or even show the current status at least not right away. After about 5 minutes the screen updates and shows the one plug setting in the wall is on and it will now respond to Off, On and toggle.
I should say I'm running Zigbee PI 4.0.6.0 on HS4 version 4.0.5.0
Comment