4.0.12 Using an awful lot of CPU.....

[Blade]

This is very odd because BLRadar is only acting on the callbacks being sent by HS4
Is rfxcomm not showing any activity on the sensors - something is causing HS to send those callbacks

[dmurphy]

I'll switchback to HS3 BLRadar plugin and see what happens.

[Blade]

The code for processing the callbacks is the same in HS3 and HS4 version of the plugin
This is odd

[dmurphy]

but isn't the sdk/capi different?

[Blade]

Yes the value changes are coming into the plugin from HS
Let me look

[Blade]

Try out 4.0.13 BETA

[dmurphy]

Every motion/dusk sensor is last device change updated every few seconds in .13 - Even though I have switched off the device string update with time option......

[Blade]

Install 4.0.14 BETA and capture me the last change date/time updating

[dmurphy]

4.0.14 installed....devices currently don't change unless a valid motion occurs. Will keep an eye on it.

All devices change regularly if the "Include Time information" in devices string is enabled.

[Blade]

Yes that is correct
Is the cpu usage better?

[dmurphy]

So far CPU is fine.....but it has taken sometime in the past for toggling to begin. Once it starts it continues.....

I'll get a pushover message if CPU load goes above 30%

[dmurphy]

It's behaved itself since yesterday....certainly progress. Devices are toggling as expected and look at the nice time spread on them.....Not all devices changing every few seconds.



thanks

[Blade]

OK good
I will release this build

[dmurphy]