-
I would recommend putting in a support ticket on this issue.
https://dev.homeseer.com/servicedesk/customer/portal/2Leave a comment:
-
I only have the Nortek. According to several guides I found the Aeotec 'driver' is chosen when setting up the Nortek controller in the Z-Wave plugin.Leave a comment:
-
If I read this correectly, you have both the Nortek and Aeotec configured as a Z-Wave interface? You may want to start wtih one or the other until you get things up and running.Leave a comment:
-
Cannot add Z-Wave iblinds device
I have created a new install of HS4Pi on a RPi 3B with a Nortek Zigbee/Z-Wave stick. I added the Z-Wave core 3.0.11.0 and Z-Wave UI 1.0.0.0.
I created a controller using the 'Aeon Labs Aeotec Z-Stick' on /dev/ttyUSB0 and started it.
I have tried multiple times to add an iblinds device but the only thing it reports back to me is: "Include process FAILED for an unknown reason. Please try again."
I have reset everything, rebooted multiple times, reimaged the SD card from scratch to see the same thing over and over.
Any ideas?
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Leave a comment: