Yale lock

[rkshack]

I must be doing something wrong. When I go to homeseer and go to control node root, there is not an option to enter a access code. I haven't looked for it on a while but I thought it was under the zwave tab.

Any suggestions?

[damiene77]

There's a couple of different ways to add lock codes in HS3 - I'm not familiar with HS4 yet but under the devices root, you would go to the 'Zwave' tab and then under 'Settings' is where you would be able to add / remove codes by slot. There is also: Plugins > Zwave > Lock Management at the top of the UI but once again this is HS3 so not sure if the same applies to HS4 or not.

[kenm]

rkshack While I assume you are running on an HS4-Pi, you'll probably get more guidance in the Z-Wave sub-forum here.