Announcement

Collapse
No announcement yet.

New error after update

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    New error after update

    I think Ultramon was one of the updates I did today as well as HS3 to 3.0.0.370 this evening.

    This error now shows up on startup:

    10/4/2017 9:46:37 PM ~!~Info~!~Plugin UltraMon3 has connected. IP:127.0.0.1:5852
    10/4/2017 9:46:38 PM ~!~Error~!~Unable to monitor because it is not valid.
    10/4/2017 9:46:38 PM ~!~Plug-In~!~Finished initializing plug-in UltraMon3


    I'm not sure if the error showed up before the HS3 update.
    Randy Prade
    Aurora, CO
    Prades.net

    PHLocation - Pushover - EasyTrigger - UltraECM3 - Ultra1Wire3 - Arduino

    #2
    I updated to HS 3.0.0.370 yesterday before the error. Rolling back to 3.0.0.368 stopped it. I'll post in the HS brea thread.
    Randy Prade
    Aurora, CO
    Prades.net

    PHLocation - Pushover - EasyTrigger - UltraECM3 - Ultra1Wire3 - Arduino

    Comment

    Working...
    X