Away for At Least xx Mins condition fails

[stipus]

Hello,

I think this is because of the way HomeSeer triggers and conditions are evaluated.

In your case:

When the BT device becomes detected, the trigger is run and the condition is evaluated: has the device been away for at least 10 minutes ? Unfortunately at the time this is evaluated, the device just became detected, and it has been away for 0 seconds.

Your condition cannot work as-is. The status cannot be away when the device just became detected.

[Delboy]

I must be doing soemthing wrong as the following trigger condition fails:-

Event Trigger = Device Value Change (tried Status as well)
Device = Registered and working BT device
Value Change Trigger = 'Becomes Detected'
Condition = 'Bluetooth Device xyz has been away for at least two minutes'

The event works fine if I do not apply the 'away' condition' but I need to only trigger if the device had previously been away for xx number of minutes?

Any ideas on a way to do this assuming the BT Conenctor conditions are known to not work without intoruding anotehr virtual device to track the status myself?