Cadd-x Wireless Help

[joeslat]

Hi everyone, I have the Cadd-x wireless motion detector NX-480, several actually, and I'm replacing batteries for the first time. I don't have my manual, so I'm hoping folks can remind me...

It seems to be in "test" mode, the light is comingon and it is firing instantly with every detection, whereas normal behavior was that it only pulsed "on" every 3 minutes, and the light did not go on (to save battery life).

Can anyone remind me how to take it out of test mode? Thanks!

Joe

[ka7gzr]

You activate the walk test mode by removing the sensor from the base which trips the tamper switch and re-installing it on the base. This puts the NX-480 into an instant on state for 60 seconds with immediate trips and LED. This should automatically time out and go to no-LED (no matter what) and a 3 minute no trip state after a trip.
Jim