Hopefully Geoff will see this one......
I'm not sure where to post this one...in here or in the Touch Pad plugin area, but here goes.
Within Plato, I have all my IR devices (TV, VCR, Cable Box, etc) set up and functioning properly. Absolutely, positively! Tested multiple times. I have reset them IR config and retested. Everything works. But now, with the new Touch Pad plugin, I want to be able to use my CF-01 or Point 510 and configure the IR setup in HS. A couple of questions relating to the IR set up as the manual and on-line helps are NOT much help.
(1). What is the purpose of putting the IR device code in the IR config? Won't HS (thru the HL plugin) use the codes in the HL?
(2). What is the purpose of the "download" button? Does this override the HL set up? Example: If I change the IR device code in HS and push the download button, does this get downloaded to the HL box and change what's already defined there?
Now for the problem: I have three IR devices defined in HS (so far); TV, DVD player, and Receiver. Each has it's own unique IR device code. Each is controlled with it's own IR emitter on a seperate emitter port on the HL box. As previously stated, I can control each without problem thru Plato. The "remote control" shows up for each on the HS web page. Thru HS however, I can only control the TV and the receiver. I cannot get HS to control the DVD player! If I click on the "download" button in the HS Ir config for the DVD player, I can then control the DVD player, but then I lose control over the TV!!
Only after quitting HS and going back into plato and resetting the IR config there can I again control all. Any help will be appreciated. If I need to move this somewhere else, let me know.
Chuck
I'm not sure where to post this one...in here or in the Touch Pad plugin area, but here goes.
Within Plato, I have all my IR devices (TV, VCR, Cable Box, etc) set up and functioning properly. Absolutely, positively! Tested multiple times. I have reset them IR config and retested. Everything works. But now, with the new Touch Pad plugin, I want to be able to use my CF-01 or Point 510 and configure the IR setup in HS. A couple of questions relating to the IR set up as the manual and on-line helps are NOT much help.
(1). What is the purpose of putting the IR device code in the IR config? Won't HS (thru the HL plugin) use the codes in the HL?
(2). What is the purpose of the "download" button? Does this override the HL set up? Example: If I change the IR device code in HS and push the download button, does this get downloaded to the HL box and change what's already defined there?
Now for the problem: I have three IR devices defined in HS (so far); TV, DVD player, and Receiver. Each has it's own unique IR device code. Each is controlled with it's own IR emitter on a seperate emitter port on the HL box. As previously stated, I can control each without problem thru Plato. The "remote control" shows up for each on the HS web page. Thru HS however, I can only control the TV and the receiver. I cannot get HS to control the DVD player! If I click on the "download" button in the HS Ir config for the DVD player, I can then control the DVD player, but then I lose control over the TV!!
Only after quitting HS and going back into plato and resetting the IR config there can I again control all. Any help will be appreciated. If I need to move this somewhere else, let me know.
Chuck
Comment