Value Status pairs

[PosterBoy]

Hi

I have a created a virtual device that has custom value/status pairs. On the Homeseer status page, Homeseer show a pull down menu to select from each of the custom value/status pairs. However, when I add the virtual device to InControl, it just gives me the option of on and off. Under the properties for InControl_Sage, it shows me the value/status pairs, but I see no way to tell the clients to select from those values.

Any hints on how to do this?

FYI, I created the virtual device to be able to control my thermostat. Right now I have a virtual device and a couple of events set up that allow me to change the thermostat mode from a pull down on the device status page. The state of the virtual device gets updated when a poll of the thermostat sees a mode change, so it goes both ways. If I can do this, then I have thermostat control from within Sage!!

Thanks

Kent

[lamanmi]

Kent,

Sorry for the delay in responding, between the holidays and vacation it has been very hectic. Right now the InControl For Sage cannot set/change the value/status pairs.

However, I am just finishing up a new version which will have both:

- built in support for thermostats
- ability to perform button pairs (i.e. custom buttons) on any HS device.

I am hoping to get the version on within this week.

Thanks.
Mike