I have been trying to get my RCS TXB16 thermostat up and running again. It worked for several years under HS 1.6. For reasons I won't explain due to space, I only a few months ago upgraded to 2.x. (I'm currently running 2.3.0.19, but it has happened in other builds the same way, I just haven't attempted to tackle the problem until now.) I can't get HS to communicate at all with the thermostat. I have tried the HS plugin, DooStat, sending direct commands, setting up devices for individual codes, different house codes... nothing works.
The thermostat functions manually fine, and I can get it to accept x-10 signals sent from wired and wireless controllers. For example, using an x-10 mini controller, decode table P and house code P, sending "P1 on" results in the thermostat changing the set point to 65, just as it should. However, sending that same command from within HS does absolutely nothing. HS logs the command (e.g., "Command sent to X-10 address P1: P1 On Dimval: 0 Data: 0"), but the thermostat doesn't receive it.
To repeat myself, the thermostat does recieve commands from x-10 controllers and responds normally. However, it does not recieve or respond to any commands sent from within HS.
Any advice would be appreciated.
The thermostat functions manually fine, and I can get it to accept x-10 signals sent from wired and wireless controllers. For example, using an x-10 mini controller, decode table P and house code P, sending "P1 on" results in the thermostat changing the set point to 65, just as it should. However, sending that same command from within HS does absolutely nothing. HS logs the command (e.g., "Command sent to X-10 address P1: P1 On Dimval: 0 Data: 0"), but the thermostat doesn't receive it.
To repeat myself, the thermostat does recieve commands from x-10 controllers and responds normally. However, it does not recieve or respond to any commands sent from within HS.
Any advice would be appreciated.
Comment