I cannot get the 1623PC to send on Com port 2

[damiller]

I have set it up on Com port 2 and it has no problem copying codes from my remote, However I have not figured out how to make it send signals. I have even tried to send right after the learn withouts success. I am at my limited wits end.
Derek

[This message was edited by damiller on Friday, 11 October 2002 at 01:19 AM.]

[mgp]

Your not alone. I have not been able to send on anything other than com1.

[Pothead]

No Xmit

Same problem with HS on any COM port. 1623PC works fine with supplied software.