Announcement

Collapse
No announcement yet.

Requires HS 2.0 or higher?

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Requires HS 2.0 or higher?

    Hello,
    I recently purchased this plug-in (2.1.0) and know very little about it. I am running HS 2.0 build 1972. I believe I've followed all the setup instructions for WAPSeer, but, must have not done something right. When I surf to http://www.mydomain.com:port#/wapseer.ash on my Treo 650, I get the following message:

    "This version of WAPSeer requires HomeSeer 2.0 or higher."

    I'm running HS 2, so, not sure what to do next.

    Thanks in advance.

    -Matt

    #2
    Got it working but ...

    Okay,
    Sorry for posting my own fix. But when I looked at the Setup->General page in the browser, I noticed under System Information for the Version line, it was blank. I was running HS as a service and have run accross quirky behavior before with HS as a service. So, I unloaded the service and ran HS interactively. When I did this I got a version number and WAPSeer started working on my Treo 650.

    However, the version number was 2.0.1955.0 and not 2.0.1972.0 like I thought I'd just installed. Going further down the rabbit hole I re-rand the 1972 fix which went okay this time. I got the 2.0.1972.0 version number and WAPSeer is still working.

    Unfortuneatly configuring HS 2 is starting to feel like playing Jenga. Once I sorted out all the above, my SLinke plugin crashed. I found the following thread for that:

    http://board.homeseer.com/showthread.php?t=106644

    Which, is exactly the problem I'm left with. WAPSeer is working and I've got the version number I expected, but, I can't run HS2 as a service until the SLinke issue is resolved. And oh, of course, my SLinke isn't working!

    -Matt

    Comment

    Working...
    X