Problems Configuring Wapseer

[amccabe]

HI All

Just purchased a license of wapseer and downloaded in updater.
In setup/interfaces configure wapseer.

Just opens the same page again ie http://192.168.0.3/conf

Anyone any thoughts.

Thanks

Al.

[JustinGould]

WS3 beta doesn't have the config page done yet (next build or the one after). There's really nothing to configure - just install and browse to it and you're good to go.

Justin

[amccabe]

I seem to have multiple versions on my machine Justin.

on the setup/interfaces
Wapseer -20 --- HSPI_WS30.DLL 3.0.1.0

When I log in to the system Wapseer 2.1
Seems to work though.

Can I just delete the wapseer files and start again as this must be an old eval install?



Regards


<TABLE cellSpacing=2 cellPadding=0 width="100%" border=0><TBODY><TR><TD class=tablerowodd noWrap align=left></TD><TD class=tablerowodd noWrap align=left></TD></TR></TBODY></TABLE>

[JustinGould]

The two different versions have different URLs. 2.1 uses /WAPSeer.ash, while 3.0 uses /ws.

As far as starting over, HS itself stores the eval key information, so a simple uninstall/reinstall won't do it. You can, however, put in a ticket at the HS Helpdesk requesting a trial extension key.

BTW, I'd very mush suggest trying the 3.0 beta, although a trial extension/purchase will enable both. It's very stable, and it has the full plug-in thermostat control that 2.1 is missing.

Justin

[amccabe]

Hi Justin


I did purchase a license.
Also my ws.ash is showing a 0KB


Regards
Al

[JustinGould]

Hi Justin


I did purchase a license.
Also my ws.ash is showing a 0KB

It's not ws.ash. Just /ws

Justin