ocelot, homeseer and touchpad

[collegeboyslive]

ok I seem to be running into problems here can anyone help me out?

I have homeseer, a fujitsu 510 touchpad on a wirless lan running touchbase.
and the ocelot with the secu16-ir board connected to the av gear and an x10 interface ( i cant use the serial interface to homeseer as they are at oposite ends of the house )

trying to control the av gear via the fujitsu.

the way i was going to do it was...

have touchbase tell homeseer to issue an x10 comment, say p1 on

then configure the ocelot to fire an ir commant when it sees p1 go on.

is this the best way to do this or is their a better way?

[gregoryx]

You will have to put in the Cmax code to tie the X10 to the IR.

First, you need to get all your IR commands "in to" the Ocelot.

Then, the Cmax is as simple as:
If X10 P/1 On Command
Then Transmit Remote Infra-Red# 2 to Module# 1, Zone# 1

(see profile for environment)