I have an Ocelot and a Secu16IR. Thanks to the fantastic help from Dan Boone I was able to get the Ocelot to learn the commands from an old Dish Network Receiver. Model 5000.
I can open up C-Max and trasmit the codes and control the sat receiver. When I start up HomeSeer and go into the IR setup gui, I select the device, click the T button and it doesn't control the receiver. I have a device that blinks when it receives IR and if I point my emitter at that device it shows a really quick IR. But when I put the emitter back on the sat receiver, nothing. The IR is sent but the receiver ignores it.
Anyone ran into this before and figured it out?
Jeff Farmer
I can open up C-Max and trasmit the codes and control the sat receiver. When I start up HomeSeer and go into the IR setup gui, I select the device, click the T button and it doesn't control the receiver. I have a device that blinks when it receives IR and if I point my emitter at that device it shows a really quick IR. But when I put the emitter back on the sat receiver, nothing. The IR is sent but the receiver ignores it.
Anyone ran into this before and figured it out?
Jeff Farmer
Comment