Hi, I am moving Homeseer to a new pc. Moving the config etc. files as read about in these posts wasn't working very well for me so i started fresh with a clean install. v 2.5.0.1. Got my HSphone working again got my ocelot working . HAI is giving be this log message at startup: OmniproII with v3 firmware:
<TABLE border=0 cellSpacing=2 cellPadding=0 width="100%"><TBODY><TR><TD class=LOGDateTime0 noWrap align=left>2/27/2011 2:53:19 PM </TD><TD class=LOGType0 colSpan=3 align=left>Warning </TD><TD class=LOGEntry0 colSpan=8 align=left>'status' property on device HAI Zones Zone 1 (1) was accessed - this property has been deprecated and should not be used</TD></TR></TBODY></TABLE>
I'm getting hundreds of these, in gold, one for each HAI unit and device and flag etc.
The plug-in seems to be working, monitoring zone and unit status as it should. This is with the beta, but this afternoon i've tried both versions with the same effect.
Whats up? Should i just ignore it ?
Thanks
Paul
<TABLE border=0 cellSpacing=2 cellPadding=0 width="100%"><TBODY><TR><TD class=LOGDateTime0 noWrap align=left>2/27/2011 2:53:19 PM </TD><TD class=LOGType0 colSpan=3 align=left>Warning </TD><TD class=LOGEntry0 colSpan=8 align=left>'status' property on device HAI Zones Zone 1 (1) was accessed - this property has been deprecated and should not be used</TD></TR></TBODY></TABLE>
I'm getting hundreds of these, in gold, one for each HAI unit and device and flag etc.
The plug-in seems to be working, monitoring zone and unit status as it should. This is with the beta, but this afternoon i've tried both versions with the same effect.
Whats up? Should i just ignore it ?
Thanks
Paul
Comment