Reset HAI Plugin

[stinggray]

When I first setup the HAI plugin I set it to port 9 like it says on the plug. There's 8 port plugs and the first one starts at 3 so I should have set HAI to port 7. Anyway now when I try change the port in config I get "The webpage cannot be found" and below is what I comes up on the log. I have deleated the HAI file in the root and reinstalled the plugin and I get the same thing when I try to config the plugin. Is there a way to delete the file or uninstall it so it dose not keep port 9 when I install it?

Thanks Craig

12/13/2011 5:58:58 PM - HAI System - About to initialize HAI System on COM9
12/13/2011 5:58:58 PM - HAI System - HAI Error: Failed to initialize HAI COM9 port. (Security Init)
12/13/2011 5:58:58 PM - COM Plugin - InitIO error:
12/13/2011 5:58:58 PM - COM Plugin Error - Error initializing Custom Interface: Failed to initialize HAI COM9 port. (Security Init)
12/13/2011 5:58:58 PM - Error - Initializing interface: HAI_System->Failed to initialize HAI COM9 port. (Security Init)

[Pete]

First shut down Homeseer. Then go to the hspi_HAI.ini file and change the very top of it. You will see a long digit for the PanelCode.

You need to set the com port to whatever you are using. So if you using com3; then set the com port to 3. Your logging shows you have it configured for com9; but if you have only 8 ports then it will be just one of those

Delete the password in the INI file; create a new one and the first time you boot it; it'll encrypt it again. Mine is set for COMPort number 10.
Make sure you utilize the Password/CODE you have configured in the panel.

[hspi_HAI]
COMPort=10
PanelModel=16
PanelCode=THISISMYPASSWORD

[stinggray]

Thanks that did it.

[Pete]

BTW I am still using the V 2.0.0.19 HS HAI plugin with the most current firmware on the HAI OPII panel. It does OK.

If you are using the newer HS HAI plugin it will not work with an HAI Omnistat plugged into you HAI panel; whether its an older RC-80 or newer Omnistat2 1000 or 2000.