I have learned from HAI today that their OmniPro II can NOT read the activity of Leviton 2-way powerline switches when the switch is activated directly? They indicate that Leviton uses some propriatary signaling and they do not plan to make it work with theirs (they admit Homeseer and most of the others can read it but their interface only works with 'standard powerline protocol' or some BS like that).
I have just had installed 8 OmniPro wall consoles, full alarm system, 8 thermostats, 8 humidity sensors, etc. I have over 100 Leviton 2-way light switches (recently had many replaced that were older because I wanted to know the true state on the consoles/panels) and the HAI can control the switches directly but it does NOT know the condition of the switches (on/off) when they are turned on and off manually. Is there anything I can do?
Is there a way to put the CM11a inlines so this system can know what is going on? What a waste! As you can tell I am p'd off.
I have learned alot of what the HAI can not do (no logging of events that take place -- well it doesn't exist unless you specifically program it individually to log it they say)...but since they do not know what the Leviton switches are doing the programming in my case would be a waste.
I love the Homeseer stuff but thought that this HAI would allow some cool additional features...what a dud...
Any thoughts?
I have just had installed 8 OmniPro wall consoles, full alarm system, 8 thermostats, 8 humidity sensors, etc. I have over 100 Leviton 2-way light switches (recently had many replaced that were older because I wanted to know the true state on the consoles/panels) and the HAI can control the switches directly but it does NOT know the condition of the switches (on/off) when they are turned on and off manually. Is there anything I can do?
Is there a way to put the CM11a inlines so this system can know what is going on? What a waste! As you can tell I am p'd off.
I have learned alot of what the HAI can not do (no logging of events that take place -- well it doesn't exist unless you specifically program it individually to log it they say)...but since they do not know what the Leviton switches are doing the programming in my case would be a waste.
I love the Homeseer stuff but thought that this HAI would allow some cool additional features...what a dud...
Any thoughts?
Comment