I'm hoping someone can help me. I get lots of these errors with my 4 Z-Wave RCS tstats:
Aborting poll of this thermostat due to and error retrieving the temperature. Node: x
I poll every 10 minutes and each thermostat polls with a 1 minute offset from each other.
I've seen some conflicting posts on if the Z-Wave Plugin should be used in the most current versions of HomeSeer. I'm running HS Pro 2.4.0.71
I currently have the plug in, version 1.3.0.8, installed an enabled.
Is that correct? If so, any suggestions on the error messages?
Thanks!
-Mike
Aborting poll of this thermostat due to and error retrieving the temperature. Node: x
I poll every 10 minutes and each thermostat polls with a 1 minute offset from each other.
I've seen some conflicting posts on if the Z-Wave Plugin should be used in the most current versions of HomeSeer. I'm running HS Pro 2.4.0.71
I currently have the plug in, version 1.3.0.8, installed an enabled.
Is that correct? If so, any suggestions on the error messages?
Thanks!
-Mike
Comment