I have a ztroller .15 sw
using intermatic modules
what is happening is that when I send a command to the tstat most times I see an error like this: Error sending fan mode command (44-2), return was ERROR ID: 28
if I check the tstat it will have updated like it should. any thoughts.
you can see where the return from the tstat is blank, I'm sure this is why I get the error.
below is the debug info
12/4/2010 10:34:13 AM ZWave Thermostats DEBUG In Thermostat.CmdSetFan: Therm=1 Mode=0Mode Type=System.Int32
12/4/2010 10:34:13 AM ZWave Thermostats DEBUG Entering SendCMD: CMD=FanSet G/S=False VAL=0 SPNum=1
12/4/2010 10:34:13 AM ZWave Thermostats DEBUG Sending ZWave Command: 44-1-0 to Thermostat at ZWaveID: 28, Looking for 0x44(O=0x44)
12/4/2010 10:34:13 AM ZWave Thermostats DEBUG Received return: from thermostat at ID: 28
12/4/2010 10:34:14 AM ZWave Thermostats DEBUG Entering SendCMD: CMD=FanSet G/S=True VAL= SPNum=1
12/4/2010 10:34:14 AM ZWave Thermostats DEBUG Sending ZWave Command: 44-2 to Thermostat at ZWaveID: 28, Looking for 0x44(O=0x44)
12/4/2010 10:34:22 AM ZWave Thermostats DEBUG Received return: 45-52-52-4F-52 from thermostat at ID: 28
12/4/2010 10:34:22 AM ZWave Thermostats DEBUG Entering ProcessCMD, CMD=45-52-52-4F-52
using intermatic modules
what is happening is that when I send a command to the tstat most times I see an error like this: Error sending fan mode command (44-2), return was ERROR ID: 28
if I check the tstat it will have updated like it should. any thoughts.
you can see where the return from the tstat is blank, I'm sure this is why I get the error.
below is the debug info
12/4/2010 10:34:13 AM ZWave Thermostats DEBUG In Thermostat.CmdSetFan: Therm=1 Mode=0Mode Type=System.Int32
12/4/2010 10:34:13 AM ZWave Thermostats DEBUG Entering SendCMD: CMD=FanSet G/S=False VAL=0 SPNum=1
12/4/2010 10:34:13 AM ZWave Thermostats DEBUG Sending ZWave Command: 44-1-0 to Thermostat at ZWaveID: 28, Looking for 0x44(O=0x44)
12/4/2010 10:34:13 AM ZWave Thermostats DEBUG Received return: from thermostat at ID: 28
12/4/2010 10:34:14 AM ZWave Thermostats DEBUG Entering SendCMD: CMD=FanSet G/S=True VAL= SPNum=1
12/4/2010 10:34:14 AM ZWave Thermostats DEBUG Sending ZWave Command: 44-2 to Thermostat at ZWaveID: 28, Looking for 0x44(O=0x44)
12/4/2010 10:34:22 AM ZWave Thermostats DEBUG Received return: 45-52-52-4F-52 from thermostat at ID: 28
12/4/2010 10:34:22 AM ZWave Thermostats DEBUG Entering ProcessCMD, CMD=45-52-52-4F-52