Hey Guys,
Check this out:
My one Tsat is showing up twice in the Zwave Thermostat Status.
Also, I can send a Mode on or off command but the setpoints are not being performed by the Stat. They are not even being shown in the log BUT, they do show on the Status pages with the new set point.
THoughts?
Check this out:
Originally posted by "Screen shot of the ZWave Thermostats Status page"[B
My one Tsat is showing up twice in the Zwave Thermostat Status.
Also, I can send a Mode on or off command but the setpoints are not being performed by the Stat. They are not even being shown in the log BUT, they do show on the Status pages with the new set point.
THoughts?
Comment