Announcement

Collapse
No announcement yet.

Cree 100 watt equivalent bulb flicker with X10.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cree 100 watt equivalent bulb flicker with X10.

    I just purchased several Cree 100 watt equivalent bulbs at Home Depot. I was hoping to use them with X10 WS12A wall switches since their actual load is 18 watts. I can report that this did not work at all. The bulbs flicker badly at all levels from 100% on down.

  • #2
    Same here with the Intermatic ZWave dimmers...
    HS3Pro Running on a Raspberry Pi3
    64 Z-Wave Nodes, 168 Events, 280 Devices
    UPB modules via OMNI plugin/panel
    Plugins: Z-Wave, BLRF, OMNI, HSTouch, weatherXML, EasyTrigger
    HSTouch Clients: 3 Android, 1 Joggler

    Comment


    • #3
      Add at least one 40 watt or more incandescent bulb on same circuit and they will work fine.Unfortunately, this means there needs to be more than one fixture on each switch that you put the florescent on.

      Comment


      • #4
        Most controllers and switches from x10 require 40 watt load minimum.

        Comment

        Working...
        X