Announcement

Collapse
No announcement yet.

Trying to control X10 UM506

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Trying to control X10 UM506

    Hi,

    I am trying to control an X10 UM506 module from HS3 but when I control the device in HS3 is does not work. I am using the TI103 interface. If I remove the TI103 interface and plug in an X10 Maxi Controller in the same outlet, I can control the UM506 interface from the Maxi Controller. What am I missing?

    Thanks in advance,

    Ronnie

  • #2
    Hi Ronnie,

    Can you control other devices with the TI103? You may not have all of its dip switch settings correct. See http://www.act-remote.com/PCC/PCCInst/ti103_instr.pdf.

    Cheers
    Al
    HS 3.0.0.548: 1990 Devices 1172 Events
    Z-Wave 3.0.1.262: 126 Nodes on one Z-Net

    Comment


    • #3
      I figured it out

      I set up the UM506 as a device in HS3 and was trying to trigger that device which did not work. Instead I made an event that is manually triggered and set it for E13 on. When I want to trigger the UM506 I run the my event which sounds the UM506 device.


      Thanks for your responses,

      Ronnie

      Comment

      Working...
      X