HandleDeviceStatus error in log

[santoal]

Hi

Just updated to latest plugin and log flooded with handle error

AK Shelly ERROR

[1826]: shellyswitch25 (SHSW-25): HandleDeviceStatus for (Ref: 1829) 40F52001626E.Relay.1 (~

Appears to be only on shelly 2.5 devices configured as blinds

[alexbk66]

Hi

Just updated to latest plugin and log flooded with handle error

AK Shelly ERROR

[1826]: shellyswitch25 (SHSW-25): HandleDeviceStatus for (Ref: 1829) 40F52001626E.Relay.1 (~

Appears to be only on shelly 2.5 devices configured as blinds

Ok, I never tested 2.5 as blinds I'll check.

[alexbk66]

It's definitely after update? Which version from - to?

[santoal]

It's definitely after update? Which version from - to?

latest version 3.0.0.92. I haven't updated for a while... may be 3 months (3.0.0.81?)
Chose to upgrade after I started getting "Dropping event call backs due to full queue". I disabled the plugin and errors dropped so figured it was it.

[santoal]

more info. Problem not occuring on a Shelly 2.5 device setup as a switch relay

[alexbk66]

Ver 3.0.0.93 - Fix Shelly2.5 in Roller mode error.

I don't have Shelly2.5 available for test, but hopefully it should work.

[santoal]

Thanks. Appears fixed.
is it possible to get roller position as a separate device?

[alexbk66]

Thanks. Appears fixed.
is it possible to get roller position as a separate device?

Possible, but why? What's the issue with current setup?

[santoal]

It would be good to see and set the "current_pos" as a value independent of the device state. The Device value is set according to the state "Open" "Close" "Stop" rendering the slider somewhat redundant once the state is refreshed (i.e. it will change to -100 for example). Should the blind state "Open" "Close" and "Stop" be independent of the current blind position and show slider as a different device with a text field for entering desired % position?

[alexbk66]

It would be good to see and set the "current_pos" as a value independent of the device state. The Device value is set according to the state "Open" "Close" "Stop" rendering the slider somewhat redundant once the state is refreshed (i.e. it will change to -100 for example). Should the blind state "Open" "Close" and "Stop" be independent of the current blind position and show slider as a different device with a text field for entering desired % position?

Got you, ok.