I'm pretty sure I have seen a thread about this but can't find it.
I have an ApplianceLinc. It controls just fine with HS3 directly and via HSTouch app. I have discovered that if you switch it on or off manually (on the ApplianceLinc itself), the device status does not change.
Is there a way to make it reflect the manual change?
I have an ApplianceLinc. It controls just fine with HS3 directly and via HSTouch app. I have discovered that if you switch it on or off manually (on the ApplianceLinc itself), the device status does not change.
Is there a way to make it reflect the manual change?
Comment