Mark,
Several of my X-10 devices (typically a wall switch) return to a "set" dim level from their last brightness level. I need to "pulse" either bright or dim commands (broadcast in X-10 protocol) to maximize or minimize the brightness level in order to begin a "new" desired "brightness level."
For example, when turning on a room light that was last being used at 50% brightness, I cannot get the module to start at full bright. It starts at 50%.
Thanks for any information.
Several of my X-10 devices (typically a wall switch) return to a "set" dim level from their last brightness level. I need to "pulse" either bright or dim commands (broadcast in X-10 protocol) to maximize or minimize the brightness level in order to begin a "new" desired "brightness level."
For example, when turning on a room light that was last being used at 50% brightness, I cannot get the module to start at full bright. It starts at 50%.
Thanks for any information.