I am a little fuzzy on the polling function.
- Under what circumstances would you set a device's polling interval to something other than zero? I would think this is for troubleshooting purposes, and that it would normally stay at zero?
- Then there is the intrinsic HomeSeer polling function, the "broadcasting antenna" icon, I assume this is what we use to have HomeSeer "catch up" with any changes while it was down (since the Power Failure Recovery function is a complete dunsel). It's pretty handy, but is that function addressable through scripting, and if so, wouldn't it make sense to just make it part of the start-up script?
Comment