Team I can't seem to find a clean set of instructions to migrate from the USB 2413U to a new Insteon HUB 2245-222
Current System running on a Dedicated HP laptop
Windows 8 PRO 64 bit
HS4 Pro Edition 4.1.11.0 (Windows)
Insteon Plugin - v3.0.7.2
I tried to follow Marks' Getting started there are references just not enough for me to get over the hump
https://forums.homeseer.com/forum/li...steon?t=158129
I'm hoping this might help other and guide folks interested in the HUB
I found the IP address of the unit using an IP Scanner tool and login/pw on the bottom of the unit. It seems I can log in but it doesn't go anywhere.
I want to set a static address but I can't seem to get beyond this page on the Hub.
How do you get into this device to set it up? Does it require an account with Insteon? (I did setup an account for this HUB on my iPAD. it required scanning the QR Code. The IP does show up inside the iPAD applicaiton however I can't find where you set a static IP.
I had hoped it only needed to be setup thru Marks. plugin or a web browser within my network.
in the screen shot below it appears to have accepted the USER/PW to show this web screen
In the Insteon Plugin I selected to Swap Interface
Entered the new Insteon HUB address 57.7d.d6 to replace the old USB PLM
Most of the Devices did not need to be reprogrammed 8 were skipped " I didn't want to walk around the property and put them in link I would fix them later
I shut down HS4 and restarted the system
I don't understand how to change the interface port from USB COM 3 to the Insteon HUB IP 192.168.199.142
I get this error to enter a valid Port
trying to figure out this error
Many thanks
Devoir
Current System running on a Dedicated HP laptop
Windows 8 PRO 64 bit
HS4 Pro Edition 4.1.11.0 (Windows)
Insteon Plugin - v3.0.7.2
I tried to follow Marks' Getting started there are references just not enough for me to get over the hump
https://forums.homeseer.com/forum/li...steon?t=158129
I'm hoping this might help other and guide folks interested in the HUB
I found the IP address of the unit using an IP Scanner tool and login/pw on the bottom of the unit. It seems I can log in but it doesn't go anywhere.
I want to set a static address but I can't seem to get beyond this page on the Hub.
How do you get into this device to set it up? Does it require an account with Insteon? (I did setup an account for this HUB on my iPAD. it required scanning the QR Code. The IP does show up inside the iPAD applicaiton however I can't find where you set a static IP.
I had hoped it only needed to be setup thru Marks. plugin or a web browser within my network.
in the screen shot below it appears to have accepted the USER/PW to show this web screen
In the Insteon Plugin I selected to Swap Interface
Entered the new Insteon HUB address 57.7d.d6 to replace the old USB PLM
Most of the Devices did not need to be reprogrammed 8 were skipped " I didn't want to walk around the property and put them in link I would fix them later
I shut down HS4 and restarted the system
I don't understand how to change the interface port from USB COM 3 to the Insteon HUB IP 192.168.199.142
I get this error to enter a valid Port
trying to figure out this error
Many thanks
Devoir
Comment