OK, I did a stupid, and installed a relay switch in the wall without writing down the Insteon address.
Now, of course, I could tear it out of the wall and read it, but it was part of a 2-gang, and I use screwless wallplates, and it took so long for me to jockey into place, keeping it exactly even with the other switch, finding the screwholes, getting it flush to the wall, etc....
And I suppose I could simply tap-add the new swtich....BUT...it's intended to replace a switch that (ahem) defecated on me, so I was going to use the magic Replace This Device button. If I were to tap-add it, my ability to transfer the programming from the old switch would go away, wouldn't it?
So basically, I'm asking if there's a way to read that address, perhaps through detailed logging or something?
Now, of course, I could tear it out of the wall and read it, but it was part of a 2-gang, and I use screwless wallplates, and it took so long for me to jockey into place, keeping it exactly even with the other switch, finding the screwholes, getting it flush to the wall, etc....
And I suppose I could simply tap-add the new swtich....BUT...it's intended to replace a switch that (ahem) defecated on me, so I was going to use the magic Replace This Device button. If I were to tap-add it, my ability to transfer the programming from the old switch would go away, wouldn't it?
So basically, I'm asking if there's a way to read that address, perhaps through detailed logging or something?
Comment