Special Note: This version will not support Smarthome devices bought after March 2012. Please use v1.7.x
New Features
- Test Communications diagnostic tool; sends 20 insteon pings to selected device and displays the results. Must put RF devices into linking mode first.
- Message hop data added to Registered Device list. See the note at the bottom of the page for a description of the columns.
- Settings for on-level and ramp rates and resume dim for i2 dimmer devices.
- Debug log message show hop data for each message received.
New Device Support
- Fanlinc support! See http://www.smarthome.com/fanlinc.html for details on the device.
Revision
- Enhanced polling for i1 KPL buttons. Faster polling for i1 & i2 KPLs and buttons
- Updated Program and Replace device routine
- Removed fast on/fast off buttons from InlineLinc device
- Added All btn to RemoteLinc; still under development
Fixes
- Bug with new installattions and house code selection
- Bug in light on at ramp rate action
- Interface Crashes trigger wasn't firing under certain conditions
To Install:
1. Backup your current hs database and insteon.ini
2. Shutdown HS
3. Copy the hspi_insteon.dll to the homeseer folder
4. For new users only: copy the insteon.lf to the homeseer\config (this will provide a 30-day trial license)
Licenses are available in the HST store:
http://store.homeseer.com/store/MNSa...n-P948C94.aspx
New Features
- Test Communications diagnostic tool; sends 20 insteon pings to selected device and displays the results. Must put RF devices into linking mode first.
- Message hop data added to Registered Device list. See the note at the bottom of the page for a description of the columns.
- Settings for on-level and ramp rates and resume dim for i2 dimmer devices.
- Debug log message show hop data for each message received.
New Device Support
- Fanlinc support! See http://www.smarthome.com/fanlinc.html for details on the device.
Revision
- Enhanced polling for i1 KPL buttons. Faster polling for i1 & i2 KPLs and buttons
- Updated Program and Replace device routine
- Removed fast on/fast off buttons from InlineLinc device
- Added All btn to RemoteLinc; still under development
Fixes
- Bug with new installattions and house code selection
- Bug in light on at ramp rate action
- Interface Crashes trigger wasn't firing under certain conditions
To Install:
1. Backup your current hs database and insteon.ini
2. Shutdown HS
3. Copy the hspi_insteon.dll to the homeseer folder
4. For new users only: copy the insteon.lf to the homeseer\config (this will provide a 30-day trial license)
Licenses are available in the HST store:
http://store.homeseer.com/store/MNSa...n-P948C94.aspx
Comment