Replace Hubs - not so clear

[ez1976]

Hey mark
i received a new HUB from smarthome since we suspect the old one is not so well.
i went into the option: Reprogram Insteon system for replacement Insteon Interface


it has a big warning paragraph which i didnt read (just kidding, read only the first line )


what i didnt understand is this:

Current Interface Installed on the system:
1E.CB.3E
Last Interface Installed on the system:
1E.CB.3E
Old Interface Insteon Address : XX.XX.XX

i need to enter the old HUB's ID? shouldnt this be the new HUB's ID?
and should i first configure the new HUB with the same IP, port, username and password? or does this process does that as well?
thanks

[mnsandler]

you first need to get the new hub online so the plugin will recognize it.

then start the swap/replace routine and enter the OLD insteon id when asked. the routine will then look for the old ID within the links and reprogram them with the new ID.