Announcement

**devoir** · January 4, 2015, 12:37 AM

Part 2

This is Part 2 of my post

I clicked on the Link Chain then chose device Garage Garage Interior Light Outer door Dual-Band SwitchLinc On/Off it created two links 5 & 6 ( I suppose this is correct)

========================================================
Here is the ProblemGarage Interior Light Mini Remote 2342-2

I did press the set button on the bottom of the remotlinc switch got a beep and a slow flashing light indicating it was in linc mode. (I also tried it without link light blinking)

http://cache.insteon.com/documentati...2-x42qs-en.pdf

**mnsandler** · January 4, 2015, 10:16 AM

A 4-way circuit requires links from each device to every other device. Each device should be registered with the plugin first. Then edit the links of each device and create links from that device to the other two devices. The one device (being edited) is the controller, and the other two are the responders.

as for the remotelinc, is the problem that it doesn't show as a Responder when trying to create a link to it from one of the other devices?

**devoir** · January 4, 2015, 04:08 PM

I have all of the devices showing up in the Currently Registered Insteon Devices. However the Mini Remote is this issue

the mini remote doesn't show up when trying to select a responder from the control device.

**mnsandler** · January 4, 2015, 04:23 PM

Ok. So the remotelinc can't be a responder; its a controller only. You might be able to create the link manually (see the manuals) but it won't do much good.

I generally hide remotelincs on the hs dev mgmt page as their status is always out of sync.

Announcement

Creating 4-Way switches with Insteon Devices

Creating 4-Way switches with Insteon Devices

Comment

Comment

Comment

Comment