I know this isn't a general Insteon support forum, but you guys seem to be more knowledgeable than the people over at the smarthome forums.
I have one ToggleLinc dimmer that seems to not reliably respond to group commands. Every other device responds every single time I send the group command, but this one is probably 50/50.
It appears to respond every time I send an individual device command.
What gives? I thought Insteon was supposed to handle these scenarios and retry?
EDIT: It should be noted that the groups in question have KeypadLinc buttons set up as their controller, not the PLM/Homeseer. This occurs when I execute group commands from Homeseer on my phone, but I haven't yet tested from the keypadlinc.
I have one ToggleLinc dimmer that seems to not reliably respond to group commands. Every other device responds every single time I send the group command, but this one is probably 50/50.
It appears to respond every time I send an individual device command.
What gives? I thought Insteon was supposed to handle these scenarios and retry?
EDIT: It should be noted that the groups in question have KeypadLinc buttons set up as their controller, not the PLM/Homeseer. This occurs when I execute group commands from Homeseer on my phone, but I haven't yet tested from the keypadlinc.
Comment