Hue Dimmer Switch V2

[chrisgla]

Is Hue dimmer switch V2 supported by Jowihue yet?

I have DeConz 2.10.04 / 14/03/2021 with Firmware26680700 and Jowihue 4.0.4.3.

I can see the switch in DeConz including button presses, but not in Phoscon

In HS4, I see two device nodes, both just showing as config with no controls:-

On bridge	Phoscon-GW 00212E054118	ID	13
Sensor manufacturer	Philips	Sensor model	RWL022
Sensor Type	ZHASwitch	Sensor Unique ID	00:17:88:01:09:27:33:11-02-fc00

ZHASwitch

**************************** Object info *****************************
{
"config": {
"battery": 100,
"group": "22",
"on": true,
"reachable": true
},
"ep": 1,
"etag": "48dcaa30b2605ef947ebd8a729bd4a48",
"lastseen": "2021-03-28T16:38Z",
"manufacturername": "Signify Netherlands B.V.",
"mode": 1,
"modelid": "RWL022",
"name": "RWL022 13",
"state": {
"buttonevent": 1002,
"eventduration": 1,
"lastupdated": "2021-03-28T16:35:39.673"
},
"swversion": "2.42.0_h1F5E860",
"type": "ZHASwitch",
"uniqueid": "00:17:88:01:09:27:33:11-01-fc00"
}
************************* End Object info ***************************

Thanks!

[w.vuyk]

Could you post an image of the device with its features and also the added values in the Status/Graphics page of the device feature? I expect this should not be hard to support....

Wim

[chrisgla]

Hi Wim,

the switch has four buttons same as the older Philips RWL021 dimmer switch.

In HS4, the two devices 2218/ 2219 appear as per the first screenshot.

In status/ graphics I have entries for key 1 - 6, each with the same 10 conditions as shown for key 1 on the second screenshot.

Thanks,

Chris

[w.vuyk]

Chris,

I think this should be good as is except for the battery device which is still missing by the looks of it. There are no controls needed as the switch sets the values you can use in events. Does the device update when you press a button?
If it does not, check the deCONZ screen, does a blue dot blink when you press any button on the dimmer? If it does not, start a scan for devices on the bridge maintenance tab and reset the dimmer (do not delete any devices! resetting the device during a scan for devices will refresh the info in deCONZ and the plugin)

Wim