-
you will just need to change the new IP of the main repeater in the config of HS3 RA2 plug-in, then it will connect and will control all your device as the old IP. All the device ans events will still work as usual.Leave a comment:
-
Changing router and IP address
I am new to HS. Played extensively with trial and purchased the SEL-PRO. I currently have a 10.0.1.x IP setup (Apple AirPort). Will likely be upgrading my wireless router after upgrading my internet speed to 1GB and go to 168.x.x.x. I have a large RA2 system, uploaded the PI and groomed the labels for ease of programming. My question is: will I need to reload the entire system when I change the IP address, or will the PI adapt when I change the setup (and not change any of my customization)? Thank you in advance.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Leave a comment: