DonMor I have one of the Radio RA2 fan switches with the Low/Medium/Medium-High/High modes. I can control the switch within HS3. However the value of the device is different when I use the wall switch than when I control it through HS3. As a result, if I use the wall switch to turn on the fan, the correct status graphic and speed value do not display within HS3. Here are the values of the device at the various speed setting when using the switch and HS3:
Fan-Speed............Set With Switch......Set with HS3
Off .................................0 ...........................0
Low ...........................25.49 .......................25
Medium .....................50.59....................... 50
Medium High .............75.69....................... 75
High.............................100 ........................100
This is also causing problems when I try to create a script to increase the value of the fan speed.
Can you fix this within the plugin? Or is there a workaround? Thanks.
Fan-Speed............Set With Switch......Set with HS3
Off .................................0 ...........................0
Low ...........................25.49 .......................25
Medium .....................50.59....................... 50
Medium High .............75.69....................... 75
High.............................100 ........................100
This is also causing problems when I try to create a script to increase the value of the fan speed.
Can you fix this within the plugin? Or is there a workaround? Thanks.
Comment