I was wondering if it is possible to manually configure the plugin instead of the discovery method? I run my lights in a different VLAN then the one Homeseer is located in. I have poked around the config files but I don't see a way to do so.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.