Running version 3.3 of the PI my interface (including or heating pump) will freeze between 8 - 12 hours. A disable and enable of the PI do not start logging.
Running version 3.1 this freeze was not there. Disabling and enabling the PI did start logging of the values.
Which parameters should I set for the settings below to have the same behaviour as version 3.1
----
John
Running version 3.1 this freeze was not there. Disabling and enabling the PI did start logging of the values.
Which parameters should I set for the settings below to have the same behaviour as version 3.1
- Read/Write Retries
- Read/Write Timeout (ms)
- Delay between each poll (ms)
----
John
Comment