I can confirm that this plug-in works with Vera Lite running UI5. I use the Vera Lite to control an Ethernet Relay Board Model ETH008. I do this because the micasaverde plug-in to control the board only works in UI5. I had been running the Vera Lite as a stand-alone controller for water valves attached to the relay board, but this meant I could only use sensors that worked with UI5. Now I can use more current sensors included into the HS system and then control the relays using the HS Vera plug-in. I have no Z-wave devices included in the Vera Lite, just the relay board. Eventually I plan to work out the scripts to control the board directly, but for now this is a good workaround.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.