After searching through multiple forum posts, it appears that the event trigger "X10: Receive X10 Command" does not actually work.
The work around seems to be to create a device (virtual or real) for each desired X10 code, then trigger the event based on status change.
Is this an accurate assessment or should I keep digging to figure out why my setup doesn't work?
Thanks,
Mike
The work around seems to be to create a device (virtual or real) for each desired X10 code, then trigger the event based on status change.
Is this an accurate assessment or should I keep digging to figure out why my setup doesn't work?
Thanks,
Mike
Comment