Hi,
since a couple of months my two Nodon wallswitches don't trigger a cental scene/event on the first press. I can't remember when this happened first since I had z-wave delay problems before, this was resolved after removing ghost nodes (at least that seemed to have done the trick, not 100% sure).
Turned on debug logging, I don't see any message in the log on first press; it seems time related, if I press it again about 5 min later it still works, but after a longer period (impossible to determine how long, very time consuming) I have to press it twice (not to shortly after another of course).
The second press can be traced in the log. Strange thing is that for one of the controllers I have to press it 3, 4 times with a couple of seconds in between before it reacts. I'm convinced this one needed a second press at first a couple of weeks ago.
Any ideas?
Thanks.
These are the wall switches: http://nodon.fr/support/NodOn_WallSw...erGuide_EN.pdf
since a couple of months my two Nodon wallswitches don't trigger a cental scene/event on the first press. I can't remember when this happened first since I had z-wave delay problems before, this was resolved after removing ghost nodes (at least that seemed to have done the trick, not 100% sure).
Turned on debug logging, I don't see any message in the log on first press; it seems time related, if I press it again about 5 min later it still works, but after a longer period (impossible to determine how long, very time consuming) I have to press it twice (not to shortly after another of course).
The second press can be traced in the log. Strange thing is that for one of the controllers I have to press it 3, 4 times with a couple of seconds in between before it reacts. I'm convinced this one needed a second press at first a couple of weeks ago.
Any ideas?
Thanks.
These are the wall switches: http://nodon.fr/support/NodOn_WallSw...erGuide_EN.pdf
Comment