Announcement

Collapse
No announcement yet.

Unhandled frame for command class: 226 Received on interface xxx Z-Net Source

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Unhandled frame for command class: 226 Received on interface xxx Z-Net Source

    During the execution of an event that turns on a bunch of lights, I get this error: Unhandled frame for command class: 226 Received on interface xxx Z-Net Source
    (ignore the xxx)

    What would cause this type of error?

  • #2
    Could be a corrupted packet. Do you always get that error when executing the event. Maybe add a slight delay between the z-wave commands.
    HS 3.0.0.548: 1990 Devices 1172 Events
    Z-Wave 3.0.1.262: 126 Nodes on one Z-Net

    Comment


    • #3
      I always use "TURN OFF (ON) all Z-WAVE DEVICES IN ROOM = ALL FLOOR=ALL" for events that are ALL OFF or ALL ON. I then use the regular device on or off so that Homeseer knows the status. The first sends one clear signal to all devices that accept it (configurable) and then the second goes device by device so that Homeseer knows the status and redunency. This stops the popcorn affect and it sends a redundant signal to all devices.

      My ALL OFF never fails and it is fast.

      Comment

      Working...
      X